Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 1999, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 21 Jun 1999 20:01:22 -0230
Reply-To:     Philip Menchions <pbj2003@INFONET.ST-JOHNS.NF.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Philip Menchions <pbj2003@INFONET.ST-JOHNS.NF.CA>
Subject:      Re: Homemade Wiring Harness Fix - where to find?
Comments: To: Rick Koller <rkoller@HELIX.NIH.GOV>
In-Reply-To:  <4.1.19990621142119.00929390@helix.nih.gov>
Content-Type: TEXT/PLAIN; charset=US-ASCII

On Mon, 21 Jun 1999, Rick Koller wrote:

> Shawn, > Here is the procedure I think you are talking about, I just did this to > my '91 gl autobox and it worked like a charm. > > Rick Koller > From: smitht@jupiter.sun.csd.unb.ca (Tim Smith) > Unsolicited endorsement, from a sample size of one vanagon: This does work, > cleared my probs immediately, so far for 14months now. My only rec. is that > when installing simply pull back the rubber boot exposing the 4 wires that > go to the connector. Find #s 2 and 4 and simply nick them for a 1/2" or so > to expose the bare copper. Pry the wire out of the insulation by pushing a > nail/knife under. Then solder the capacitor right across the bared loops of > copper. No 15cm leads, no fighting with connector lugs etc. Use some > electrical tape over the solder sites then tuck, everything neatly back > inside the rubber boot. The capacitor I used was a 25Volt 22microfarad > tantalum type. I read of mention of the stuttering problems not being > completely solved with 10ufd size, quoted from a LIMBO article (via email) > maybe? > NOTE: it says to use #2 as positive, #4 as negative !!! I used it this way. > Any electrical geeks wanna tell if it makes a diff in this application? > Prolly. > > Radio Shack # RSU 11295805 > Can somebody tell me where the capacitor is installed? Is the above referring to the connections on the AFM or the ECU? I always assumed it was the AFM but a recent post from Darrell Boehler mentioned something about his digitool with optional capacitor fix being incorporated right into the ECU.

TIA Phil Menchions 89 Westy Torbay,NF


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.