-----Original Message----- From: Cliff Ober [mailto:cdo9@csi.com] Sent: Thursday, June 24, 1999 10:14 AM To: 'Woody Halsey' Subject: RE: On the road again!!!!
Hi Woody, A capacitor (also known as a "cap") is a two leaded electronic component which opposes any change of voltage between the leads. It can be used to smooth out a pulsating voltage like is sometimes produced by the AFM on our vanagons in response to the intake of air to the cylinders. The ECU can sometimes be confused by the pulsation, so VW came up with the $100 harness addition to the AFM. The harness has nothing but a couple of connectors to add a capacitor to the circuit, and pass on the signals from the AFM. You, (or your mechanic) can add the cap to the AFM wire harness for about 50 cents plus the time to solder it in place. A good place to insert it is inside the rubber boot of the connector that mates with the AFM. The boot can be rolled back to provide working room. Contacts 2 and 4 of the connector can be released and pulled out far enough to solder the cap's leads to the back of the contacts, which are then re-inserted in the connector body. The boot can then be rolled back up over the cap and onto the connector. Releasing the connector contacts is done by inserting a small pin (I used a tiny jeweler's screwdriver) into the front of the connector to depress a small barb which retains the contact (the barb should be bent back out slightly after release to make sure it catches when the contact is re-inserted). The capacitor can be obtained from Radio Shack. It should be a tantalum type with a value of 22 microfarads, and a voltage rating of 25 volts or higher. This type of capacitor has a polarity to it that will be marked with a plus sign, dot, or some feature to mark the positive terminal. The cap's positive terminal should be attached to the AFM connector contact #2. For what it's worth, this modification did not have any effect on my "stumbling" problem - I'm still looking... I'm going to post this reply to the list as well as to you privately so that others may benefit, and so that just in case I've erred somewhere in this, it will be corrected. Keep an eye out there for other responses. Cliff -----Original Message----- From: Woody Halsey [mailto:WoodyHalsey@compuserve.com] Sent: Wednesday, June 23, 1999 7:01 PM To: INTERNET:cdo9@CSI.COM Subject: On the road again!!!!
Dear Cliff, I was struck by your reference to "stumbling" problems, since that is precisely what I have experienced with my '83 Vanagon. Usually just briefly, and at 30 and/or 50 MPH. I have recently exchanged my ECU and AFM, installing used parts. Any thoughts? What is a capacitor and what does it do? I am clueless, but could get my mechanic to put one on, if it would make my engine run more smoothly. Thanks, Woody Halsey '83 Vanagon '64 Bug '89 diesel Jetta (this one runs reliably!) |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.