In a message dated 6/22/99 2:48:37 PM, vanpire@BIBBS.COM wrote: <<Any and all advice will be appreciated. BTW, I'm going to use the needle to inject it through the boot. Never taken a axle off a vanagon before, but the outboards look difficult to put a wrench on. TIA. Fred 89 Westy >> Fred, Putting a hole in your CV is not a good idea. If you must, at least clean the area and dab some rubber cement or other type of sealer to cover the holes. The CVs will fling the grease around inside the boot, and it will come out the holes even if they are pin sized. I tried this trick on my '74 when the CV started to clatter on a camping trip. I tried to seal up the holes, but I still had grease coming out as I drove. Steve Lashley '74 Campmobile '93 EV MV http://EuroCampers.com Importing German Side Tents, Carver Propane Heaters and other Accessories for Bus, Vanagon and Eurovan |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.