Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 1999, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 22 Jun 1999 15:03:02 -0400
Reply-To:     Bulley <gmbulley@BULLEY-HEWLETT.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Bulley <gmbulley@BULLEY-HEWLETT.COM>
Subject:      Re: Mark Stephens six-stud system
Comments: To: "Brian W. Block" <bwblock@xoommail.com>

Mark Stephens is a smart guy, selling decent products.

I would talk with him and find out exactly how many Vanagon customers using the setup, how long they have used it, and whether they have any complaints. Ask if you can speak to a couple of them.

The 96mm/six-stud setup seems great for a vehicle that needs more HP and is shoving a light load, like a autocross 914 or a 411, or (especially) a competition sandrail. It doesn't seem well suited (in my opinion) to the needs of a Vanagon, where you need more torque, more than you need more HP.

Further, since you are pushing a heavy load, and the 96mm pistons and un-shrouded heads are prolly going to build up a bunch of heat, and I am not real clear on how MSHP dissipates that extra heat...I guess what I am saying, since it is a new system, with prolly less than a hundred real life tests, and far fewer on your particular vehicle, PROCEED WITH CAUTION.

G. Matthew Bulley Bulley-Hewlett & Associates www.bulley-hewlett.com Cary, NC USA 888.468.4880 tollfree

-----Original Message----- From: Brian W. Block [SMTP:bwblock@xoommail.com] Sent: Tuesday, June 22, 1999 2:30 PM To: vanagon@GERRY.VANAGON.COM Subject: Mark Stephens six-stud system

Hello VW fans:

I am new listmember, and owner of '83 vanagon (air cooled). I am experiencing loss of compression from leakage around cylinder head. Am considering going to the "six stud system" from Mark Stephens-- This includes oversize pistons and sleeves and two additional studs to bolt on cylinder heads for each side. I figure this should cure leaks and provide some additional hp as well. Does anyone have experience with this setup? How well does it work?

Regards,

BWB

______________________________________________________ Get your free web-based email at http://www.xoom.com Birthday? Anniversary? Send FREE animated greeting cards for any occassion at http://greetings.xoom.com


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.