Date: Sun, 11 Jul 1999 18:11:32 PDT
Reply-To: vwvanman@EXCITE.COM
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Robert Lilley <vwvanman@EXCITE.COM>
Subject: Re: WOLF FLIES
Content-Type: text/plain
On Sun, 11 Jul 1999 13:36:00 -0500, Tom Hubbard wrote:
> Hi Robert. I've been driving my '88 Westfalia for two years. I just
bought
> a '90 at an auction. I'm beginning to look into mechanical things and saw
> your message about increasing mpg by adjusting "FI."
>What is "FI"
I rebuilt my engine changing stock the cam lift and duration. I also put on
a new airflow meter. It was not adjusted, so I had to adjust it to work
with all the engine changes. I set the AFM to the old AFM settings. It was
running lean, so I increased the CO content to increase fuel amount. I also
added an adjustable fuel pressure regulator. The engine is breathing air
faster so it needs the fuel to the valve quicker. Plus the adjuster is more
sensitive to vacuum loads.
and tell about the H&R SPRINGS:
My 88 Wolfsburg came with the lowered factory springs. It was lowered about
1.5" from the standard ride height of the earlier vanagons. The H&R
springs
lowered the front @1" lower in the front(the ride height at the front
spoiler is at 9"). The rear was lowered about 2". The front ride height
did not decrease because the angle the van was at is closer to horizontal
now. The rear dropped more than the front thus now decreasing the front
clearance much.
The cornering has improved a lot. Curves that required me to slow down,
now
give me no trouble. I might still add sway bars to improve the
handlingfurther.
I feel the bumps a little more now, but I felt them with the old
springsalso.
I had been concerned with the springs carrying extra weight in addition to
myself and the van, But I am more. I had an extra 500 pounds in my van
(family members) and the rear sank down about a quarter inch. The ride did
not get harsher either.
IMPORTANT: If you and when you change the springs GET an alignment before
you drive much to avoid extreme tire wear. ALL the angles are changed. You
will chew the inside edge of the tires up. Plus remove the side covers
before the alignment: left single and right rear quarter panel so they can
get to the rear adjustment bolts.
Robert
_______________________________________________________
Get your free, private email at http://mail.excite.com/