There was a thread earlier about adding a grab handle on the drivers side. Somebody made the mistake of drilling the wires. Proper procedure was drilling a small hole then putting a guide wire in to hold the wires back. Do a search for more details. It should be the same procedure. You'd still have to find the brackets of an older westy and modify the cot. Good luck, Ray --- "Henning, Eric" <Eric.Henning@bailey.com> wrote: > Probably ok to just bolt it to the a pillar, just a > little nervous drilling > into it (has a wire bundle running down the inside) > > thanks > > eric > > >As I recall, the bracket on my 71 Westy was merely > >bolted onto the a-pillars. > > _________________________________________________________ Do You Yahoo!? Get your free @yahoo.com address at http://mail.yahoo.com |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.