Since I just recently replaced the main shaft oil seal in my transmission and it's fresh in my mind, I thought I'd post the procedure for the archives. If you're seeing oil seep from the junction of the trans and the engine, or you look up at your starter motor and see it wet with oil, or you're experiencing clutch chatter, you might be a candidate for this procedure. Of course, oil can also be coming from the engine oil seal, but the character of trans oil is very different from engine oil and you should be able to tell the difference. If you separate the engine from the trans and determine the engine oil seal is OK, then its most likely the transmission main oil seal that's the culprit. I'd advise having an oil seal puller (that wicked-looking double-hooked tool) since the main shaft rubs right up against the seal, making it hard to get a hold of the seal any other way. You can also use a large washer, slightly bigger in diameter than the seal itself and with a middle hole large enough to slip over the main shaft, to seat the new seal into place. With the engine separated from the trans and the trans oil drained: Unclip the release (throwout) bearing from the release lever and swing the release lever up out of the way. Remove the 3 bolts that hold the release bearing guide sleeve and remove the sleeve. Remove the main shaft seal in the usual fashion, i.e., destroy it with the sharp point of the seal puller until it falls apart enough that you can finally pull it out. Be careful not to scratch or gouge the seal recess; chip away at the seal carefully. Clean out the seal recess with a rag or some paper towels. Oil the nnew seal and push it into place with the washer. I found I could do this without having to resort to using a piece of pipe big enough to slip over the main shaft. Replace the guide sleeve and release bearing. Fill the trans with oil. When I asked the list about replacing this seal one respondent recommended removing the transmission bellhousing to accomplish the task. While this would undoubtedly make the act of extracting the seal itself easier, I don't really see that it's necessary, and you always run the risk of damaging the gasket between the bellhousing and trans. Another respondent said he replaces the seal every time the engine is out. Its easy enough to replace the seal and I probably will follow this recommendation.
--------------------------------------------------------------------- Tom Young young@sherlock.SIMS.Berkeley.EDU Lafayette, CA 94549 '81 Vanagon --------------------------------------------------------------------- |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.