Hi folks! I surf through archives but don't found any comments or tips about changing the drive belt of 1,6 TDSL engine. Is it possible to do this job without mass of special tools (according to Bentley manual chapters 13 and 23). The tension of belt and valve and injection timing must be correct. Are there any common ways (and tools) to do that job? I'm gonna change tension roll with belt. The official service steals you $400 for that job!! Regards, Juha Koivisto 88 Vanagon (Bus) 1,6 TDSL
[text/html]
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.