Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (August 1999, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 13 Aug 1999 01:37:38 -0700
Reply-To:     "Thomas D. Hanlon" <hanran.inc@CWIXMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         "Thomas D. Hanlon" <hanran.inc@CWIXMAIL.COM>
Organization: The Hanran Enterprises, Inc.
Subject:      Re: Blinking Red Light
Comments: To: Todd Last <Rubatoguy@MINDSPRING.COM>
Content-type: text/plain; charset=us-ascii

RE: Flashing red light and no apparent coolant system cause, e.g., boiling, steaming, fan-running, etc., look to see if the fuel gauge, the clock, and/or the coolant gauge are erratic, or erroneous---- BEFORE you see the dealer. If they are, check the "voltage stabilizer" on the windshield side of the dash panel, under the removable hood.. It is mounted next to the clock on my 84 Westfalia. It should test 9.5 to 10.5 volts while the ignition is turned on. If it ranges above or below those numbers, it is faulty. (Bentley 90.4 Figure 2, "Voltage Stabilizer.") The part is about $12.00 at VW dealer, and the parts man as local dealer says it is common to VW products. Mine failed, and thanks to dagbear and Noto-Gaudette, my problem was solved by replacing the stabilizer, The main symptoms in my case were the flashing red light, "slow" clock, and the coolant level/temperature off the scale and no apparent coolant temperature range excess. Before replacing the voltage stabilizer, I checked the thermostat, flushed and changed the coolant (which the van needed), and, in general, hassled unnecessarily.

I posted, recently, this information. See the Archives.

Tom Hanlon Palm Springs, CA 1984 Westfalia

Todd Last wrote:

> Page 37 of the 1988 Volkswagen Vanagon and Transporter Owner's manual: > > WARNING LIGHT > > For a bulb check the red light in the coolant temperature gauge will flash > for about 3 seconds when the ignition is turned on. > > If the light flashes while driving, the engine may be overheated because of > low coolant level or V-belt damage. > Move the vehicle a safe distance off the road, stop the engine and depress > the emergency flasher switch. > > The fan should be operating when the warning light is on (listen for fan, > located in front of the car behind grille.) > > If a visual check shows that the coolant level and V-belt are normal, but > the warning light continues to flash, > contact your nearest dealer to have the cause located and corrected. > > Todd > '88 Westy


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.