Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (August 1999, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 9 Aug 1999 00:15:22 -0700
Reply-To:     Richard Ferguson <rfergus23@YAHOO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Richard Ferguson <rfergus23@YAHOO.COM>
Subject:      Re: Van dies when cold
Comments: To: EMZ <vw4x4@FYI.NET>
Content-Type: text/plain; charset=us-ascii

My 85 Westie was doing this but on the back side of the idle, in other words it idled at first but then when it dropped down to the lower rpm idle after warm up it would stall...this was due to a vacum leak. hope this helps, Rick

--- EMZ <vw4x4@FYI.NET> wrote: > Strainge ...My Syncro is doing this. I'm thinking it > is an electrical > connection problem, or a ground problem. I will be > in the engine > compartment Monday night. > > Eric 86-VW4x4 > vw4x4@fyi.net 72-240z > Pittsburgh, PA USA 1936-Chrysler > > > On Sun, 8 Aug 1999, Greg Mueller wrote: > > > I have had a problem with my 86 Vanagon that I > haven't been able to > > solve for about a year and a half. It is > intermittent and only does it > > 3-4 times a month. > > > > I can't figure it out. Maybe one of you have come > across this one and > > were able solve it. I sure would like to know what > the answer is. > > > > The problem is that when the van is cold > (overnight) and you start it it > > will stall and not idle. It feels like the engine > is not being fuel > > enriched. I changed the coolant temperature sensor > and checked the > > connections to the computer. Didn't help. The idle > stabilizer appears to > > be working. It hums and the van runs and idles > fine once it warms up. A > > friend thought it could be the computer and lent > me one that we knew was > > good. Still didn't fix the problem. Finally I > figured that it had to be > > the idle stabilizer control unit. We replaced it > with a known good > > control unit. I have checked all the wiring and I > have good connections > > everywhere. I don't know what else there is to > check. Any suggestions? > > > > Greg Mueller > > Huntington Beach, CA > > > > 86 Vanagon > > 70 Ghia > > >

_____________________________________________________________ Do You Yahoo!? Bid and sell for free at http://auctions.yahoo.com


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.