Another question. Three years ago we replaced our seals with ones from Bus Boys-mistake. They are very thin and fragile. I had also made by far the WORST mistake anyone can make by removing the flat seal, leading edge of pop-top. The one Bus Boys sent was just the same round rolled as the side and didn't fit at all well. I have since bought a flat seal from someone else and glued it on but I remember at the time, learning from some vendor on the list that they had a aftermarket seal available that was ONE piece-three sides with the roll-type seal, one with the flat seal, completely assembled, no cutting or gluing. For the life of me, can't figure out who it was. Does anyone know? Time to replace them again, this time I want to do it right. Wendy & John Cape Cod, MA '85 Westy, "S-CAPE" CAMPERS ON CAPE COD-SEPTEMBER 1999 |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.