This under normal conditions should never need adjusted. In order to make an adjustment you must remove the master Cyl. BTW while your in there grease the fork real well. This is a weak point that were out. Eric 86-VW4x4 vw4x4@fyi.net 72-240z Pittsburgh, PA USA 1936-Chrysler
On Tue, 31 Aug 1999, John Hurley wrote: > Date: 08/31/1999 10:26 am (Tuesday) From: John Hurley > To: vanagon@gerry.vanagon.com > Subject: clutch adjustment > > Yesterday i tried removing the master cylinder mounting bolts on my 85 westy in order to get at an adjustment rod which i was told is on the top of it. Has anyone else tried this? I couldn't get a wrench on what i think is a nut over the pin. What will this adjustment do, and what size nut is that anyway? > > thanks > > john > 85 westy > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.