Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (September 1999, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 13 Sep 1999 09:15:50 EDT
Reply-To:     JordanVw@AOL.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         JordanVw@AOL.COM
Subject:      Re: Weekender seat/bed into my '81--How do you install it?
Comments: To: vw4x4@fyi.net
Content-Type: text/plain; charset="us-ascii"

In a message dated 9/13/99 7:31:03 AM Eastern Daylight Time, vw4x4@FYI.NET writes:

<< The seat is a bolt in installation, except for the pins located at the top of the seat back. These pins must be moved. You must remove the plate from the donor, and weld them into your Van. This is a reletively simple thing to do, if you have welding experience. >>

ive installed these in plenty of vans, and never use the seatback locking pins. its not necessary to use these, as the seatback stays up without them. so there is no welding involved. chris


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.