Item Subject: cc:Mail Text Hi Mark, I seriously doubt that the Graz factory balances the shaft in the vehicle. The shaft is located by a flange that slides into a mating feature. It is vitally important that the axis of rotation at the shop that does the balancing is referenced to the center of the alignment flange not the attachment bolt holes as these are not necessarily centerpoint referenced. IMNSHO this would have been a much better design with the inclusion of a replaceable hardy disk. Al |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.