Folks, In trying to remove the whole rear bench assembly, one of two screws holding the assembly to the van sheet metal (the ones that are accessible from the rear hatch) broke in its socket. What is the best way to go about this problem without having to go the re-threading route? I can see a section of the threaded part of the broken screw coming through the right/rear wheel well. Éric |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.