Easiest way is just to pull the boot back from the body end, and visually check if there are any broken ones. They almost always break in the center of the boot. Karl
----- Original Message ----- From: Kelly Bauman <bauman@ICAN.NET> To: <vanagon@GERRY.VANAGON.COM> Sent: Friday, September 24, 1999 12:55 PM Subject: Wire checking / Multimeter Use
> Hi Listees: > > I need to check for broken wires in the rubber boot going through my > drivers side door. I have a multimeter but am not clear on how to test the > wiring (where do I poke the probes?). > > If anyone can send me instructions I would be grateful. Please p-mail me > at bauman@ican.net as I am currently not on the list. > > Thanks > > Kelly Bauman > Delta, BC > '91 Westy |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.