Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (October 1999, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 1 Oct 1999 10:27:49 -0700
Reply-To:     Stuart MacMillan <stuart@COBALTGROUP.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Stuart MacMillan <stuart@COBALTGROUP.COM>
Organization: The Cobalt Group
Subject:      Re: Need help with rust- window frame
Comments: To: KENWILFY@AOL.COM
Content-Type: text/plain; charset=us-ascii

Ken,

It depends on how long you want the repair to last. The only long term fix is welding in new metal to replace all the rusted out areas. When you get to the pinhole stage the metal is very thin, and usually rusting from the inside too.

If it is not worth this much effort, wire brush and paint with a rust killing paint like Corroless from Eastwood, and fill over the Corroless with polyester filler. I like catalyzed glazing compound for easy sanding and finishing in this type of repair.

Applying the Corroless to the metal and putting filler on top will prevent moisture from ever getting to the weak metal from above, or contact metal through the filled pinholes from the inside. In addition, deep rust is almost always impossible to completely remove, some is usually left between layers of corroded metal. This will keep on rusting under filler and paint; the Corroless is supposed to stop this process. Filler sticks just fine to paint and primers that are in good condition.

(On my "strip to bare metal" paint jobs I first level out large dents, welds, etc, and apply epoxy primer to the entire car. Then I apply the fillers on top of the primer. This process requires that you re-spray primer after sanding to cover the newly exposed metal, but ensures that no rusting will occur through a paint scratch over filler, which absorbs moisture and will conduct it to the bare metal below. This is more expensive and labor intensive, so pro refinishers don't use this method.)

If you can get Corroless on the inside, so much the better.

I have used this technique for several years now with no rust through problems so far!

Have fun! -- Stuart MacMillan Manager, Case Program 800-909-8244 ext 208

Getting your share of the Net yet? http://www.cobaltgroup.com http://www.casedealer.com/demo http://www.caseihdealer.com/demo


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.