Date: Thu, 7 Oct 1999 17:19:31 -0500
Reply-To: Carl Hansen <carl_hansen@IEEE.ORG>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Carl Hansen <carl_hansen@IEEE.ORG>
Subject: Re: Small tranny leak in front end
Content-Type: text/plain; charset="us-ascii"
One of the Syncro Transmission joints does not take a gasket. It's one of
the front joints. You use a sealant instead. I know because the shop that
provided my rebuilt Syncro Tranny FORGOT to use the sealant and just put it
together w/o. Leaks, of course.
I'm not next to SyncroBeast or Bently so can't tell you which joint it is,
but it is one of the front most joints. If it is leaking at that point, I
understand that the bolts can be taken out, the nose taken off, and the
sealant added. Be sure to jack up the front of the van to make sure it
doesn't leak lots and lots of tranny fluid, or at least drain before
procedure.
(Of course, you remove the drive shaft as well, or at least disconnect at
rear.)
Ch
'89 SyncroBeast Vanagon - Soon to come - New Shocks for the Syncro!
Soon as I get rid of the rust. ugh
'87 16V GTI
'80 850 Yamaha Special
'87 16V GTI w/ hale damage - parting out - body gone, parts remain
'89 16V GTI w/ toasted motor
'86 Scirocco (8 valve w/ auto) - SO's - now w/ it's own hale damage
Prior Lake, MinneSnowta - Allmost Winter! Yeah!
**** SNIP ORIGINAL ****
Date: Wed, 6 Oct 1999 18:07:49 -0600
From: Peter <printstud@BIGFOOT.COM>
Subject: Small tranny leak in front end
Dear Fellow Syncronauts,
I'm sifting thru the vanagon site trying to find an answer to the
following question and wondered if any of you had any thoughts on it?
I have a small leak on the transmission of my '87 syncro. It appears
to be about one drop a day on average, maybe less or more (?). It is
comming from where, according to the description in the Bentley manual, the
"output housing" meets the "low gear housing" or inotherwords , not where
the driveshaft meets the begining of the transmission, but at the next joint
of two housings, but still in the very front of the transmission. It is
also possible that there may be a small leak at the next junction, where the
"low gear housing" meets the "transmission", but before the transmission
housing itself. It may well be that the leak is in the former and that the
wind (while driving) just blows it back to the latter.
Does this sound like a serious leak?? I'm wondering if I could just
put some silicone around the leaking area on the outside, to stop it? This
is a new ( within 3 years and only about 12,000 miles) rebuilt transmission
from VW of America.
I am also just about to replace the transmission fluid in it. I was
going to use redline mt-90 but then I heard it encourages leaks and I dont
want to encourage this one. If I dont use a synthetic, what is reccomended
for a petro based oil? Is it true that you only want to use a GL-4 and if
so where do you get it? The local flaps autostores only have gl-5 or -6.
Thanks for sharing any thoughts and experience, Peter
Printstud@bigfoot.com
|