VANAGON archives -- October 1999, week 4 (#113)

Date:         Sat, 23 Oct 1999 13:16:05 -0400
Reply-To:     Bob Donalds <bostneng@FCL-US.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Bob Donalds <bostneng@FCL-US.NET>
Organization: Boston Engine Exchange
Subject:      Re: Help Clutch Pilot Bearing question!
Comments: To: The Bus Depot <ron@NETCARRIER.COM>
Content-Type: text/plain; charset=us-ascii

The Bus Depot wrote:
>
> > Does anyone know if this style of bearing will work or do I need to
> > remove(sigh) and replace it with the open style bearing?
>
> The included bearing is correct for a Vanagon (and, in fact, for most VW
> busses as well).
>
> - Ron Salmon
>   The Bus Depot, Inc.
>   http://www.busdepot.com
>   (215) 234-VWVW
Ron
no vw im aware of uses a closed end pilot bearing
 I also just matched up the right parts and the shaft does need to
protrude
the kits I have on hand do have the right bearings in them
I use a #111 103 313a
Bob

Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.