Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (October 1999, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 23 Oct 1999 17:19:49 EDT
Reply-To:     JKrevnov@AOL.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Rico Sapolich <JKrevnov@AOL.COM>
Subject:      Re: Help Clutch Pilot Bearing question!
Content-Type: text/plain; charset="us-ascii"

Gary: If you do a little accurate measuring, you'll be able to determine if the pole fits the hole, so to speak. Measure: 1/ The O.D. of the pilot on the input shaft. 2/ The I.D. of the pilot bearing. 3/ The distance the bottom of the blind bearing is below the mounting face of the clutch housing. 4/ The amount the input shaft protrudes above the face of the x-mission mounting flange. Allow a bit for working clearence and you should know if it is meant to be. Rich


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.