Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (October 1999, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 22 Oct 1999 21:04:19 +0200
Reply-To:     Per Lindgren <lindgre@ONLINE.NO>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Per Lindgren <lindgre@ONLINE.NO>
Subject:      Re: coolant pressure guage
Content-Type: text/plain; charset=us-ascii

The heater core is in line with the engine, not the radiator, so it will show the same pressure that's currently in the engine. The radiator doesn't have any pressure until the thermostat opens.

PerL 87 Syncro 112i

Alistair Bell wrote:

> how about "T"-ing into the cooling system at the bleeder screw on the > radiator? Is the bleeder screw a National Pipe Thread or something else? If > it is NPT then it would be straightforward to plumb in the pressure sender > or tube. > > alistair


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.