In a message dated 10/30/1999 1:26:01 AM Eastern Daylight Time, bratjen@DIRECT.CA writes: >... (you have to take out the whole hall unit and > readjust timing later) > Not if you remove the clamp from the BLOCK and not loosen the adjusting bolt. I removed mine from the block during a rebuild and was careful to install the drive correctly back in, then I put the distributor back and DID NOT change the timing. It fired immediately and when the timing was checked, It was in perfect time. Although I would check it after, to make sure... Robert |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.