Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (November 1999, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 3 Nov 1999 22:30:00 -0600
Reply-To:     Rob & Lrae Winterkorn <volksman@ENTERACT.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Rob & Lrae Winterkorn <volksman@ENTERACT.COM>
Subject:      shake, rattle, what up
Content-Type: text/plain; charset=us-ascii

I have done a complete tune-up: plugs, wires, cap rotor, filters. The oxygen sensor checks out to be ok from the resent post of the hot, cold test. What is it that causes the engine to have a slight miss and shake at idle?

Gas mileage is between 18-21, and runs great warm, a little stumbling when cold .

Since the bucking situation (thanks again all who helped) I installed the in line diode from one of my other parts vans. I have not had bucking since.

Thanks for any input

Rob

1990 Gl 2.1, 120k


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.