Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (November 1999, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 11 Nov 1999 22:07:14 -0500
Reply-To:     Scarlett Semko <damosem@MAIL.MCO.BELLSOUTH.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Scarlett Semko <damosem@MAIL.MCO.BELLSOUTH.NET>
Organization: Pre-installed Company
Subject:      Re: creaky steering wheel
Comments: To: Randy Bergum <organslave@EARTHLINK.NET>
Content-Type: text/plain; charset=us-ascii

I learned this from some good soul on the list. I cannot remember who posted it, but if your reading this step up and take some credit here because the noise drove me nuts till I fixed it.

Behind the plastic that surounds the steering column I acouple of screws and it comes right off) there are two bolts and a bracket that hold the column. Loosen the bolts, do not remove them, pull up on the steering wheel, and tighten the bolts back up. I had to have some help, one person pulling up, and the other tightening. Fixed.

I must mention here that this noise occured after I let the boys at the VW dealer try to fix my inop. horn, which was still inop when I picked it up, but I had gained a noise every time I turned the wheel. Guess the figured it hould work instead of the horn?

Ron Semko Orlando, Florida

Randy Bergum wrote:

> Hi Thomas: > > I just fixed a squeak in the steering wheel - it was the main steering shaft > rubbing a hole in the tape wrapped around it, which then rubbed on the little > boot at the floor where it goes under the car. Couldn't find the same kind of > tape, so I shot some McLube 1725L spray onto it and the noise went away. This > stuff has teflon in it and is hard to find. We use it for lubricating the key > pins in organ and piano keyboards - works reel guuuud! > Also, the horn contact will squeak if not greased - clean the track with > anything, then put a light dab of grease on the running area. You can do this > without pulling the wheel, but it's harder, tho. > > Randy Bergum > 1990 Carat. > > Thomas Penberthy wrote: > > > I have an 89 Westy GL which runs like a dream...except that the steering > > wheel creaks like an old barn door whenever I turn it. > > > > Is there some sort of trick for eliminating this noise short of removing the > > hood off the steering wheel? > > > > TIA > > > > Tom > > Marlin - 89 Westy


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.