Date: Thu, 18 Nov 1999 08:03:27 -0500
Reply-To: Bulley <gmbulley@BULLEY-HEWLETT.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Bulley <gmbulley@BULLEY-HEWLETT.COM>
Subject: Re: heating start-up
We still enjoy fab heat in our aircooled 1982, and I know the current owner
of our old 1976 loves his heat: he lives in Boone, NC (mountians, cold).
If you still feel cold in your van, check www.bulley-hewlett.com/VWindex
for answers.
G. Matthew Bulley
Director
Bulley-Hewlett & Associates
www.bulley-hewlett.com
Cary, NC USA
888.468.4880 tollfree
-----Original Message-----
From: Mark Perkins [SMTP:MCPerkins7@AOL.COM]
Sent: Wednesday, November 17, 1999 8:30 PM
To: vanagon@GERRY.VANAGON.COM
Subject: Re: heating start-up
I worked as a VW mechanic for 10 years and hate the cold! Some of my tips
for
staying toasty are:
Air cooled:
- Put extra non flammable insulation. non water absorbing on the main duct
from the heater boxes.
- Add non flammable, non water absorbing, heat proof insulator on outside
of
heater boxes. I used to use this muffler wrap that hardened with heat, but
haven't seen it lately.
- Fill all the hollow spots behind the panels with fiberglas or foam make
sure it can't absorb water or it will cause rust. On the front panel under
the dashboard
I used styrofoam packing pellets. I could just feed them in by pulling the
panel out a little.
-Put 1 inch carpet foam under the front and rear mats.
-When it got around 20 degrees or less I used to put a clear plastic sheet
behind the front seat to keep the heat up front and block the heater vent
for
the rear.
-Make sure the slider vents at the bottom back edge on the front doors
are
open
-Various seat treatments I've used are. Reflector sheets such as space
blanke
t material, covered with sheepskin or regular seat covers. I currently use
a
heated seat cushion with massager which is fantastic, they have them at
Sears
for $40.
Waterboxers
-Put closed cell pipe insulation around all visible heater hoses on the
underside.
-When the temperature averages less than 40 degrees I cover 3/4 of my
drivers
side air intake with a piece of sheet aluminum that clips over the plastic
louvers.
Remember to remove in warm weather or you will over heat.
- Fill all the hollow spots behind the panels with fiberglas or foam make
sure it can't absorb water or it will rust.
--Put 1 inch carpet foam under the front and rear mats.
- Reflector sheets such as space blanket material, covered with sheepskin
or
regular seat covers. I currently use a heated seat cushion with massager
which is fantastic, they have them at Sears for $40 and worth 3 times the
price, what I originally paid!
|