Larry; It will work IF the pulling force is applied to the inner race of the CV joint. I had to adapt my gear puller to accomplish this. I attached the arms to two piece of inch square stock bolted on either side of the shaft behind the CV joint. The end of the axle has a dimple that accepts the center screw of the puller. Drive Safely & Good Luck Ken Lewis<Kernersville,NC>86 VW crewcab;60 T-5 Coupe On Thu, 25 Nov 1999 17:29:37 -0500 Lawrence Johnson <larry_avery.johnson@SYMPATICO.CA> writes: >I have heard that a wheel puller will do the job. Has anyone tried >one? >-Larry ___________________________________________________________________ Get the Internet just the way you want it. Free software, free e-mail, and free Internet access for a month! Try Juno Web: http://dl.www.juno.com/dynoget/tagj. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.