Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (December 1999, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 4 Dec 1999 19:01:11 EST
Reply-To:     kenneth d lewis <kdlewis@JUNO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         kenneth d lewis <kdlewis@JUNO.COM>
Subject:      Re: Coolant Level Sensor: modify & install
Comments: To: austins@IX.NETCOM.COM

BTDT. I over tightened the sensor and ripped the head right off. Since I
was in B.F.Egypt on a Sunday I repaired it with JB Weld.  After about a
week the JB Weld absorbed the anti-freeze, became spongy and failed.
Drive Safely & Good Luck
Ken Lewis<Kernersville,NC>86 VW crewcab;60 T-5 Coupe


On Fri, 3 Dec 1999 22:30:05 -0800 Austin <austins@IX.NETCOM.COM> writes:
>1)  get a brand new sensor; turn it uppside down & swab out the cavity
>with
>alcohol + q-tips.  Fill the cavity with epoxy (JB Weld), let it cure &
>install per 2) below;
>


___________________________________________________________________
Why pay more to get Web access?
Try Juno for FREE -- then it's just $9.95/month if you act NOW!
Get your free software today: http://dl.www.juno.com/dynoget/tagj.
Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.