John- There are a number of list-certified vendors, and decent machinists on our list. I don't want to suggest one over another, since I think you might want to listen, and make your own conclusions. I can tell you one group to avoid: Mark Stephens High Performance. I will fill the list in on all the details later this week. But leave it to say, these guys were a squirrelly on the customer service, and I should have taken my $$ elsewhere. As of today, they have had six months to reimburse me a chunk of $$ they owe me. MSHP---is OFF my list. G. Matthew Bulley Bulley-Hewlett Corporate Communications Counselors www.bulley-hewlett.com Cary, NC USA 888.468.4880 tollfree ------------------------------------------------------------------------ ---------------------- Get your FREE semi-private E-mail account, use your computer at work.
-----Original Message----- From: John Brush [SMTP:jbrush@AROS.NET] Sent: Sunday, December 19, 1999 9:53 PM To: vanagon@GERRY.VANAGON.COM Subject: Re: Air Cooled Conversion >You aren't an idiot. A moron, maybe, but certainly not an idiot. Hey, you did just forget the smiley after that, right?? :) >You CAN get acceptable power from the 2.0 liter without going into >crazy-weird stuff. Consider the following relatively inexpensive >improvements to your stock 2.0. I am thinking I might go such a route. I spent enough time under the hood of my race cars as a kid that I can probably do it myself. The wife left me, so I have lots of time, and room in the garage <g> Will I find a listing of all the 'special tools' that I will need to do the pull out, rebuild, and reinstall, in the archives. I am not much on VW engines, but its all pretty much the same. I just hate it when I go to work on a vehicle and find that I need a torx tool, or something unique that I need to go to a dealer to get. I am of the impression that there is enough knowhow in the group and in the archives to get me through it. Thanks a lot for the pointers. Sounds a lot like what I would do to get more out of a 327 Chevy. Where should I shop for the heads, the crank, and the bigger pistons?? Should I just buy them, or rework the ones I have? Much obliged. Regards from Utah, John |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.