Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (December 1999, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 20 Dec 1999 06:00:51 -0500
Reply-To:     Bulley <gmbulley@BULLEY-HEWLETT.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Bulley <gmbulley@BULLEY-HEWLETT.COM>
Subject:      Re: Air Cooled Conversion
Comments: To: "jbrush@aros.net" <jbrush@aros.net>

OOOOPS. Yes, I forgot the wee smiley. :)

Your nincompoop.

G. Matthew Bulley Bulley-Hewlett Corporate Communications Counselors www.bulley-hewlett.com Cary, NC USA 888.468.4880 tollfree

---------------------------------------------------------------------------------------------- Get your FREE semi-private E-mail account, use your computer at work.

-----Original Message----- From: jbrush@aros.net [SMTP:jbrush@aros.net] Sent: Sunday, December 19, 1999 9:53 PM To: Bulley Cc: vanagon@gerry.vanagon.com Subject: RE: Air Cooled Conversion

>You aren't an idiot. A moron, maybe, but certainly not an idiot.

Hey, you did just forget the smiley after that, right?? :)

>You CAN get acceptable power from the 2.0 liter without going into >crazy-weird stuff. Consider the following relatively inexpensive >improvements to your stock 2.0.

I am thinking I might go such a route. I spent enough time under the hood of my race cars as a kid that I can probably do it myself. The wife left me, so I have lots of time, and room in the garage <g>

Will I find a listing of all the 'special tools' that I will need to do the pull out, rebuild, and reinstall, in the archives. I am not much on VW engines, but its all pretty much the same. I just hate it when I go to work on a vehicle and find that I need a torx tool, or something unique that I need to go to a dealer to get.

I am of the impression that there is enough knowhow in the group and in the archives to get me through it.

Thanks a lot for the pointers. Sounds a lot like what I would do to get more out of a 327 Chevy.

Where should I shop for the heads, the crank, and the bigger pistons?? Should I just buy them, or rework the ones I have?

Much obliged.

Regards from Utah,

John


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.