----- Original Message ----- =
Sent: Monday, December 18, =
2000 3:58
AM
Subject: Re: Help! Won't =
Start
Hi Don,
Assuming you =
have a
digifant
1 First =
when you turn
on the key the fuel pump must run for a couple of seconds. The =
fuel
pump is powered by a relay above the coil. The relay is =
energized by the ecu. The ecu is powered by another relay in =
the box
above the coil. The latter relay is energized when the key =
is in
start or run position.
2 To get
fuel injector pulses or coil pulses you need hall =
pulses. Watch
the tach it should twitch with each hall pulse.
Darrell
----- Original Message ----- =
Sent: Monday, December =
18, 2000
1:52 AM
Subject: Re: Help! Won't
Start
I've lokked over and rechecked =
every
conenction on the motor. Could the hall sender have anything to =
do with
it?
-Don
----- Original Message ----- =
Sent: Sunday, December =
17, 2000
11:01 PM
Subject: Re: Help! =
Won't
Start
So today I was cleaning up =
my engine
compartment. Everything went back together fine, but now my =
van
won't start. I have my Digitool hooked up and it shows =
that
the Injectors and the coil aren't firing. Did I forget
something? I've checked every wire and tube. Everything =
looks fine.
Any ideas?
Recheck all the =
connections....
something was not hooked up right... pay particular =
attention to the
wire that goes from the coil to the
distributor....
Bill