Skip to main content
Gerry | Vanagon
Checking account...
← vanagon.com home · Continue the discussion in the forum
Subject:Re: exh stud - drilling out is tough
From:Stephen Grisanti
Date:Wed, 4 Jul 2012 11:52:00 -0700

This is what my hired-gun welder tried, but it did not work.� While researching this beforehand I found the technique even works on bolts/studs broken off flush.� What you do in that case is find a washer with a hole just slightly smaller than the bolt diameter and weld right in the center so washer is welded to end of bolt, then weld a nut onto that washer to give you something to turn.� I was really excited at the prospect of one of these methods working, but alas...

I console myself now for the time and effort and extra expense by reflecting on how much I learned.� Yeah.

Stephen

--- On Wed, 7/4/12, Dennis Haynes <d23haynes57@HOTMAIL.COM> wrote:
For the one with a stub you can try mig welding a nut to the
stud. The new found wrench surface and heat shock will often get the stud
loose enough to turn out.

Dennis