Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (August 2000, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 26 Aug 2000 19:32:09 -0500
Reply-To:     Christopher Darilek <cdarilek@daxcontrol.com>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Christopher Darilek <cdarilek@daxcontrol.com>
Subject:      Re: Help unusual? bucking
Comments: To: alienj@usa.net, vanagon@vanagon.com
Content-Type: multipart/alternative;

I just solved my bucking today having found my cylinder head temp sensor was loosely screwed in. Mine bucked at all speeds, but in particular downshifting as well as the upper end of each gear. It also became difficult to start. I think this flaky temp signal to the ECU was causing it to go rich and in such conditions my plugs were unable to fire. Replacing the plugs, cap, rotor, and wires, always helped the problem but was never a permanent fix until I found this loose temp sensor.

Good luck, Christopher Darilek

On Sat, 26 Aug 2000 17:25:36 EDT, CHRISTOPHER FRYER wrote: >hello, i have searched the archives so please dont flame me for that, but most >of the situations in which bucking occures for the majority? of people is at >highway speeds (please correct me if im wrong) i am at a fairly normal >elevation, not in a mountain or anything, and it has just started occuring to >a degree where i am in fear of being stranded somewhere. so heres my backround >info. >i just had my driveshaft joints replaced, new clutch, new exhaust >(disconnecting o2 sensor does nothing to help) and had a minor tune up, i >think he adjusted my throttle, thats the only thing i can think of that maybe >he could have done, as i didn't notice it before, but i also had such a rattle >that i didnt worry about anything else. mine doesnt occur at highway speeds at >all, in fact over 45 it runs smoother than i ever remember it. it usually >occurs downshifting in the range of 2000 to 2700 rpms and pushing the clutch >in stops this. also starting has become much more difficult, sometimes it >takes 4 or 5 tries to start. please, any help that can be given would be much >appreciated. >thank you >christopher fryer >87 syncro gl > >____________________________________________________________________ >Get free email and a permanent address at http://www.netaddress.com/?N=1 -- Christopher Darilek, cdarilek@daxcontrol.com on 08/26/2000 at 7:25:16 PM


[text/html]


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.