In a message dated 12/26/2000 11:55:10 PM Eastern Standard Time, LISTSERV@GERRY.VANAGON.COM writes:
> Gary, I have seen the square drive at the hub of the front left wheel start > to round off. This means that at a certain stage it will > be engaging and disengaging. This will cause the needle to register > unevenly. If this is your problem you may be able to move the cable a little > to get it onto the square part but I am not sure. > Regards, Ron Olsen > I have had success in welding to the end with a mig welder then filing the end square again so that it fits in the square hole of the grease cup. Happy Holidays Frank Condelli Almonte, Ontario, Canada '87 Westy & Lionel Trains Member: <A HREF="http://www.vanagon.com/">Vanagon List</A>, <A HREF="http://www.bcn.net/~limbo/">LiMBO</A>, <A HREF="http://www.westfalia.qc.ca/CIW_English.asp">IWCCC</A> & Capital City VW Club Vanagon/Vanagon Westfalia Service in the Ottawa Valley <A HREF="http://members.aol.com/Fkc43/stebro.htm">STEBRO/Vanagon Stainless Steel Mufflers</A> <A HREF="http://members.aol.com/Fkc43/busindex.html">Frank Condelli & Associates</A> or http://frankcondelli.com
[text/html]
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.