Hi all, After rebuilding a 2.1, I torqued the heads on by the book with a new German gasket set. The engine ran good and did not leak. After running the engine only a few miles I put the Vanagon away for a few days planning to button things up when I had time. In two days I happened to notice the passenger side head was starting to leak coolant. I looked at the gasket on the top of the head on the front corner and the gasket was pushed out funny. I took the head off and the new rubber gasket had a diagonal split about 3/4 inch long that cut the sealing face of the gasket in two. Has this happened to anyone else or did I just get a bad gasket? The heads are the original heads that came off of the engine. Any ideas? The gaskets had the VW mark on them so I assume they are OEM. Thanks, Todd Francis
[text/html]
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.