I have a solution for ya (did the same thing on my intake pipes). I used some solvent and a large L-bent bristle brush found at your local Homebrew shop. Let the solvent set for a minute and then simple run the brush through a couple of times. Worked great for me. Don Preston '87 Wolfy GL ~Betsy the Mp3 Bus~ ----- Original Message ----- From: Steve Gough To: vanagon@GERRY.VANAGON.COM Sent: Friday, May 11, 2001 12:49 PM Subject: Cleaning intake manifolds
Dear List, I'm doing an engine replacement on my '86 Vanagon. The intake manifold pipes (the four "spider legs") have a LOT of carbon in them. Most is in the bend (center of pipes) where it's hard to get at. Any tips on getting this stuff out, short of a couple of hours with a little wire brush? TIA, Steve
[text/html]
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.