Hello All, I'm a new member and have recently acquired an 85 Westy. The wires to the faucet have been snipped and I am unsure which wires in the harness that I need to reconnect them to. I am hoping that someone knows of a labeled photo or diagram showing the wiring harness in the cabinet under the sink that I can use as an aid to help me understand the electrical system. Because the wires were snipped, I am guessing that the PO had problems with either the faucet or the pump. I have learned by reading the archives that sometimes the impeller gets stuck due to mineral deposits, and sure enough my pump's impeller was stuck. I spun it around a number of times to loosen it up and now it seems to move freely. I am hoping the fix is that easy but can't test it until I know where to wire the faucet to. Also, I am wondering if my faucet is not broken (it's the kind with the dial on top and a single screw securing the top) since the dial only spins a few degrees (or perhaps this is how they are supposed to function?). Any and all insight would be appreciated. Peter 85 Westy
[text/html]
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.