Date:         Thu, 17 Sep 2009 00:17:32 -0400
Reply-To:     Dennis Haynes <d23haynes57@HOTMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Dennis Haynes <d23haynes57@HOTMAIL.COM>
Subject:      Re: Flywheel maching specs 1986 Syncro
Comments: To: Roland <syncronicity1@GMAIL.COM>
In-Reply-To:  <38e334640909151244t5ea725ffyafc09fb4d49e1d8c@mail.gmail.com>
Content-Type: text/plain; charset="us-ascii"

It is also important that the wear surface is above the center of the
flywheel. I have seen the disc center springs worn out from rubbing on the
flywheel center. VW used to sell these rebuilt. The rebuild was metal
sprayed to build up the friction surface and they were ground, not cut on a
lathe.

Dennis


-----Original Message-----
From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of
Roland
Sent: Tuesday, September 15, 2009 3:44 PM
To: vanagon@GERRY.VANAGON.COM
Subject: Re: Flywheel maching specs 1986 Sybcro

Neil,

Here is a mail from the archives.
http://gerry.vanagon.com/cgi-bin/wa.exe?A2=ind0801c&L=vanagon&F=&S=&P=55730

"

The hard and fast number for all 228 MM flywheels is .970ths I have a dept
gauge with a digital read out that sits next to my flywheel grinder for this
purpose A vernier caliper can also be used to measure dept

Its common to see flywheels that are out of spec from prevoius incounters
with a mad machinest suprpising most worked without complant

Bob Donalds

Boston Engine

"

This was in response to the question:  "

> Anyone have specs (either factory or hard and fast)
> for the depth of a stepped flywheel--ie from the
> pressure plate mounting surface to friction surface?
> How can one determine the depth needed if confronted
> with a flywheel that may have been machined
> improperly.

"

Hope that helps.  Found via google search string:  ["flywheel specs" site:
gerry.vanagon.com].  You might want to repeat this search and see some other
emails on the subject.


Roland

On Tue, Sep 15, 2009 at 11:27 AM, CPPoillon <cppoillon@yahoo.com> wrote:

> I need the flywheel machining specs for the distance between the mounting
> surface and the friction surface.  1986 Vanagon Syncro
>
>
>
> Neil Poillon
>
>
>
> 724.538.3800
>
> 724.316.3802 cell
>
>
>
> cppoillon@yahoo.com
>