Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (April 2010, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 22 Apr 2010 08:37:37 -0700
Reply-To:     Don Hanson <dhanson928@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Don Hanson <dhanson928@GMAIL.COM>
Subject:      OK, Swepco gear oil..
Content-Type: text/plain; charset=ISO-8859-1

I just changed-over from MT-90 Redline to Swepco 201 in the gearbox of my 5sp manual tranny. Here are my impressions.

The two are very different. The Redline has the consistency of light motor oil or maybe even power steering fluid...very 'thin'. The Swepco is more the consistency of molasses. Really "messy" stuff. When you lift your fingers out of a puddle of the Swepco you get these little "threads" coming off...they blow away like cobwebs. Very 'sticky-feeling'... I was working in about 45f temps. I also have some Valvoline 80w-90w Gear Oil on hand. That seems to be right between the two in viscosity. I used one of those inexpensive gear oil pumps that you screw into the container and pump by hand, stroke by stroke, right out of the jug. I doubt if you would be able to use the "gravity-feed" method unless you had all day. Very tedious to pump it in by hand..took about an hour to transfer. Thick, sticky, messy stuff. It comes only in gallon containers and my tranny uses just over a gallon. I used a little of the Valvoline to make up the difference after researching that the two would be compatible, Pumping in the little Valvoline top-up of 'normal' gear oil (about one pint) was easy compared to the Swepco.. First impression is the Swepco makes my gearbox quieter. I don't notice any shifting difference (again, ~40f operating temps) but I imagine in cold temps the thicker consistency would be felt. The used (~25K mi) Redline I drained was quite clean and my magnetic drain plug had few shavings on it. Good stuff, that Redline..I guess, but my gearbox was a little noisy using it...under hard acceleration from a stop, usually when turning onto a highway to match into traffic, I had a 'growling' noise from the rear that I didn't much fancy...That is almost gone with the Swepco in there... So I am going to keep using the Swepco because it "feels" more 'slippery' and "sounds" like it makes things work better back there. But if I were to move to Alaska and drive in winter, I would probably go back to the Redline..and if I find gear shavings on my next change...again..back to the Redline.

Not very scientific, this report..but take it for what it's worth..

Don Hanson


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.