84 vanagon Speedo cable from bearing to box with my oxygen sensor reset switch seems to be broken at or inside the bearhing housing. How does that end of the cable come out? There is a rubber plug thing that the cable goes through. It looks like that cable should be jammed into the bearing housing. Instead, that thing has slid up the cable a ways and does no good at all. Has that exposed the interior of the bearing to dirt? When I jack up the car and spin the wheel hard with the engine in neutral it goes *maybe* 2 around before stopping with a soft grind. Could that be dirt that has pile in through the loose-fitting cork thingie? Unrelated.... sort of..... should I think about repacking my wheel bearings? Steve
[text/html]
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.